Just wondering if anyone has had this problem with their S-9. When I turn on the power the word "On" flashes on the fron of the receiver continuously and doesn't stop. This happened about a year ago and I just left in on and after about 15 minutes the flashing stopped, the receiver booted up and all has been fine since then. Last weekend the flashing "On" reappeared. I left the receiver on for over an hour and nothing changed. Anyone ever seen this happen?
Thread: "On" flashes continuously
Results 1 to 9 of 9
-
"On" flashes continuously – 02-05-2013,12:07 PMOptibox Anaconda, X2, OpenBox-S9, CS8000 and 2 X CW700S, 7 1/2' Perfect Ten scanning 55W to 139W C Band and a 39" Q-Sat scanning 30W to 125W Ku Band
-
02-05-2013,12:25 PM
Have you try re-loading the firmware using a null cable and your pc?? I have heard a lot of bugs on the Openbox but not this one. Pixl came up with a fix for the No Signal (PTC resetable fuse on the main board) and recently a fix for the constant reboot (8 pin dip SD4844 on the power supply board) when using a motor.
X2 Premium III HD, Openbox X5/ S10, Gsky V3/V6, iSmart m100
-
02-05-2013,02:22 PM
EC,
I have seen that a few times on early firmware, I just re-booted once or twice and it cleared it.
I later installed the 7-17-11 FW (the best version in my opinion) never saw the "on" thing again.
What ver are you running?
-
-
-
02-05-2013,02:28 PM
easy c have you ever had to take your box and bring it to the computer and use the 232 null cord as the way to fix the open box as in recovery?
Last edited by TunaDude; 02-05-2013 at 02:36 PM.
-
-
02-05-2013,04:36 PMX2 Premium III HD, Openbox X5/ S10, Gsky V3/V6, iSmart m100
-