My X2 receiver has been losing all of quality and signal .I have swapped to a another receiver and all connections and lnb and switches work good . So it is in the receiver can anyone help. I have been installing and working on satellite systems for over 25 years, so I have check the oblivious !
Thread: X2 receiver no signal
Results 1 to 10 of 23
-
X2 receiver no signal – 02-28-2014,06:42 AM
-
02-28-2014,09:04 AM
What are the H and V voltage values at the back of the receiver?
.
.
.
Meine Dreambox One ist ein Stück Scheiße!.
-
02-28-2014,01:06 PM
It will be 13.5 and 18. and then nothing, I check more than once . I changed the thermal resistor and am testing it, its worked for 3 hours so far. But it has worked for 8 hours then stop working. So I see what happens
-
02-28-2014,01:15 PM
can you post a picture of what you replaced and where it is on the board...please. thanks
-
02-28-2014,03:32 PM
The replaced part made no difference stop working, but still has 13v and 18v in the back. Also it does not automatically turn on the V-Box.
-
03-04-2014,06:30 AM
Well I figured it out it was the thermal resistor and the diseqc switch. Thank for the help.
-
03-04-2014,07:11 AM
can you post a picture of what you replaced and where it is on the board...please. thanks
-
03-06-2014,08:07 AM
My camera is broke have to wait to post picture, the part is in the power supply area it is black with NTC 100-7 ON IT. i HOPE THAT HELPS
-
03-06-2014,08:26 AM
thanks, I will look for it. if you do get a picture please post it. My X2 is having similar problems,,,,almost like LNB is shorted ...even when no lnb is connected. i used a meter to measure continuity from coax ground to coax power and there is too much continuity and thus a short somewhere. i did this with no coax on it, but with the top off and directly on the tuner. The "short" causes box to constantly restart never tuning or staying on more than 3 seconds...without lnb or coax attached.
Edit: It is putting out voltage though.
-
03-06-2014,09:33 AM
I think we should send this inputs to Mrs Wang at X2sat so they can take a look and see is there any part being used out of specs or poor quality.
X2 Premium III HD, Openbox X5/ S10, Gsky V3/V6, iSmart m100