Edision OS Mio+ Receiver A No Output Voltage

[MikeB]

After working flawlessly for over 10 months (still under warranty), today my Receiver A of my Mio+ stopped working. I have measured the output voltage on Receiver A and there is none. I compared to Receiver B which has 13 volts (V transponder) and 19 volts (H transponder).

The way I discovered the problem was that Receiver A stopped moving my USALS motor. Receiver B moves it without issue. I use the motor all the time.

I also have always followed the habit of physically unplugging the Edision from AC power any time I connect or disconnect the dish feedlines.

My question: Is there any chance this could be a software issue that can be rectified? Or is this most certainly a hardware issue that can only be resolved by repairing the hardware?

I would try a different power brick on it FIRST. Maybe swap in the one from the other receiver that's working.

[cyberham]

I would try a different power brick on it FIRST. Maybe swap in the one from the other receiver that's working.

Mine is the Mio+ with two receivers. So there is only one AC adapter involved. Anyway, I got it working again now.