I use only 1 lo of 13850 and adjust the tps from the opposite polarity to that lo...only have one polarity available to each stacked lnb so they cant change.
Anyway I found a solution/workaround !!!!!
I change the ones that werent working to Cband LO. That apparently released the control of the 22. So even though they are KU lnb I set the LNB in E2 to be a cband LO. Then adjusted the tps frequencies to that of 5150 instead of 10750 and wala it worked. The bandstacked lnbs on only one polarity must mess with the 2.0 and cause it to tryand fit all the ranges from both polarities and 22 on/off onto the 4 ports....therfore messing everything up..when changed to cband lo then it removes that "thought" since one is ku and one is "cband"
Ha tricked it...knew there was a way!
Thanks for all of your help!!!!!!!!
Results 31 to 35 of 35
-
09-08-2017,09:36 PM
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Kiss My Assel bandido thanked for this postel bandido liked this post
-
09-08-2017,09:44 PM
LOL
I guess you could use the Ka lnb setting the same way.
Glad you found a way to make it work!.
.
.
Meine Dreambox One ist ein Stück Scheiße!.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assmountaineer thanked for this post
-
09-08-2017,10:03 PM
BTW,
That is a very nice switch! Found a Video of it.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assmountaineer thanked for this post
-
09-09-2017,05:15 AM
Would you believe I got it for $40 shipped on ebay? I was shocked...it is an excellent switch...almost no insertion loss.
Thanks for all of your help!
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assel bandido thanked for this post
-
09-09-2017,08:07 AM
I think the NimManager file could be changed so the LOF changes automatically in the receiver when the polarity switches.
Here is an incomplete example:
if currSat.voltage.value == "polarization":
if config.Nims[slotid].diseqc13V.value:
sec.setVoltageMode(switchParam.HV_13)
else:
sec.setVoltageMode(switchParam.HV)
elif currSat.voltage.value == "13V":
sec.setVoltageMode(switchParam._14V)
sec.setLNBLOFL(10750000)
sec.setLNBLOFH(10750000)
elif currSat.voltage.value == "18V":
sec.setVoltageMode(switchParam._18V)
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assmountaineer thanked for this post