The accuracy of the blind scan on my Azbox Premium+ receiver is unrivalled. If it's there then this box will find it, unfortunately a blind scan can be extremely slow unless you change a couple of default settings in the blind scan menu. These changes take only seconds and the receiver will blind scan a sat from about 10-15 minutes approximately.
[Only registered and activated users can see links. ][Only registered and activated users can see links. ]
Unfortunately my camera isn't the best.
You need to change the minimum frequency from default of 3000 to 3700(unless 3600 for a couple of Atlantic sats)
Scan step needs to be changed from 5000 to 15000.
These 2 minor details will increase the blind scan speed on the Premium+ without it missing any tp.
Thread: Azbox Premium+ Blind Scan
Results 1 to 5 of 5
-
Azbox Premium+ Blind Scan – 03-11-2013,01:50 PM
-
-
03-15-2013,07:45 AM
One of the first things you can do to increase the blind scan time is to delete all but 1 of the transponders on the sat you are scanning.
The firmware has all kinds of junk in the transponders listings which slows down the process of the blind scan.
I have found that by deleting everything but 1 tp it decreases the blind-scan time quite a bit.
-
03-15-2013,10:35 AM
5000 Khz = 5Mhz.
15000Khz = 15Mhz.
If you change the scan step to 15000, then you may miss at least two 4 Mhz transponders in one scan step!
How many transponders are missed with the 15000 setting will depend on the spacing of the transponders. I prefer using a much smaller step than this. EB.
.
.
Meine Dreambox One ist ein Stück Scheiße!.
-