VonWeise 24 inch actuator

[Terryl]

Anyone have a parts layout diagram for a 24 inch VonWeise actuator?

Mine went FUBAR and I need to see what I am up against if I try and repair it my self, 200 smackers for a new one is a bit outside my budget right now.

But replacing the limit switch actuators (they fell apart) and the micro switch is not.

[Costactc]

Although I am using 2 VonWeisse jacks at the moment I do not have any specs on them at all.

[Terryl]

Darn...And I can't fine any listed on-line ether.

I sent an E-mail to the company to see what they have.

[ViP3R]

I grabbed this off the net..hope it helps.

[Only registered and activated users can see links. ]

[Terryl]

Thanks, I have seen that one, I think mine is an earlier model as my limit switch cams do not have the two set screws as shown in that drawing.

And the internal lay out is a bit different, I will try to go take a photo, that may help.

[ViP3R]

Thanks, I have seen that one, I think mine is an earlier model as my limit switch cams do not have the two set screws as shown in that drawing.

And the internal lay out is a bit different, I will try to go take a photo, that may help.

I see.. bummer, well hopefully VonWeisse will send you something, they seem a pretty good company.

[Terryl]

Here are a few photos.
[Only registered and activated users can see links. ]
[Only registered and activated users can see links. ]
[Only registered and activated users can see links. ]

The last one shows the cam that has the center part crumbling apart.

But it's for the East/West limit switches, the problem I think may be the little square black item in the top photo, that may be the sensor I need.

[Terryl]

This is the little black square thingy that may be the sensor that is FUBAR.

[Only registered and activated users can see links. ]