Blindscan

[Costactc]

Will give it a shot and report back. Have I told you how much I really like this receiver, even though my tv upstairs is only compatible with 60hz and the image is never set to that all I do is open Webif and use the remote control buttons on my laptop to set it right.

[Costactc]

The PBnigma image already is equipped with blind scan but it's not functional. There isn't any other downloadable plugin:

[Only registered and activated users can see links. ]

[Costactc]

Manual scan is really fast with PBnigma, there must be a way to get blind scan working.

[Only registered and activated users can see links. ]

[el bandido]

this is the satellite.xml out of my receiver

The satellite file is OK. Try a different image like OpenPLi if that is the file from your receiver. These receivers may not blindscan correctly if the satellite file contains bad information or if the ssatellite file is empty, or has has no stored transponders for the satellite being scanned

The PBnigma image already is equipped with blind scan but it's not functional. There isn't any other downloadable plugin:

What is not functional about it? What does it do or not do???

[rodder]

I am using OpenPLi i switched this morning i saw no change in the scanning

[Costactc]

The satellite file is OK. Try a different image like OpenPLi if that is the file from your receiver. These receivers may not blindscan correctly if the satellite file contains bad information or if the ssatellite file is empty, or has has no stored transponders for the satellite being scanned



What is not functional about it? What does it do or not do???

It crashes every time I attempt a blind scan. I registered on the PB site and I've been advised to do a software update as blind scan is supported and working. I'll give it a shot. This image is a keeper.

[Costactc]

Even after a software update it crashes every time I attempt a blind scan.

[el bandido]

The crash log will tell you why it crashed, or at least give some clues.

[el bandido]

I am using OpenPLi i switched this morning i saw no change in the scanning

Another Solo2 owner will need to blindscan the same satellites as you have and see if they get the same results.

[Costactc]

The crash log will tell you why it crashed, or at least give some clues.

How do I get the crash log?

Another Solo2 owner will need to blindscan the same satellites as you have and see if they get the same results.

Once I pass my actuator wires, I will post back with results of my blindscan of Amc 21.