I started testing my new Optibox Anaconda HD receiver today. My first impression was WOW, but after using it for a few hours I quickly became frustrated. Each blind scan took at least 30 to 40 minutes! Plus it discovered the same channels my Openbox S9 receiver found in only a few minutes.
To make things worse I tried to recan SES2, because the LPB channels were not discovered during the first scan and the next scan zoomed to 81% and stopped. I then deleted all the channels and performed a blind scan again only to have the same problem occur. Then the "Exit" button stopped working. I had to power down and go through the entire language, time zone and channel scans again.
Attached are images showing the scan as well as the firmware version. If anyone could please help I would greatly appreciate it.
Thread: Anaconda Blind Scan Problems
Results 1 to 10 of 54
Threaded View
-
05-05-2012,01:33 PM