My Openbox X5 has FW dated Feb 2014. After setting everything up, I'm trying to save my settings to a USB drive. When I access the page for doing this, the last option is Load/save. When I click on the option the only choice is to load a DB to the box. (No option to save)
The X5 manual shows Load and Save on 2 separate lines. My screen only shows one.
Am I missing something?
Thanks
Thread: Save Database
Results 1 to 3 of 3
-
Save Database – 06-16-2014,12:23 PM
-
06-16-2014,01:34 PM
You need to have the USB inserted in the box before accessing the Edit Channels section. When you go to the Load/Save DB area you need to hit OK over the /udska1 directory you will see immediatly the Save DB blue boton in the right lower corner.
Note:
USB should be formatted as FAT32X2 Premium III HD, Openbox X5/ S10, Gsky V3/V6, iSmart m100
-
06-17-2014,05:51 AM
Thank you very much Carlos! I was too busy looking at the "Load By USB" at the top of the screen and did not see the "Save" at the bottom.