Just installed a 90 cm Ku dish with a HH-90 positioner. Coax run is roughly 150â of RG-6 Quadshield. Using an Edision OsMio 4K receiver. Titanium Satellite verified all parameters are set appropriately for my system (thanks to Brian Gohl).
All works well without the DISEqC in line. When I install the DISEqC switch I still get a good signal from both LNBâs but the Stab wonât move the he dish.
Any ideas???
Results 1 to 4 of 4
Threaded View
-
DISEqC Switch in line prevents positioner from working – 03-27-2021,07:44 PM
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssViP3R thanked for this post