If anyone has an old DMS Intl Hot Dish 90 sitting around, I could sure use some info.
If you have the time, I would appreciate the measurements end to end of the #10 feed support and #11 feed support tube. Thanks.
Filetage: Hot Dish 90
Results 1 to 5 of 5
-
Hot Dish 90 et ndash; 02-08-2013,01:17 AM
-
02-08-2013,01:49 PM
I have one lying around in my basement. The pic is a bit sketchy, is it the the throat and lnb holder length that you want?
-
02-08-2013,04:28 PM
Yeah, the bracket (square) that holds the lnb holder and the two circular tubes that hold the lnb bracket.
Thanks...
-
02-08-2013,04:41 PM
In total, just under 5". The first part, before the curve is just under 2" and the upper part where the lnb is held is 3". Damn, I just realised I have 4 mesh panels for a 10' bud, 2 90cm and an 18" dish in my utility room.
-
02-08-2013,08:18 PM
Thanks Costactc...
Don't forget to check the attic, you may find more valuables.. LOL