I flashed the latest file as ALL CODE on my x2 III and I bricked it. The display only shows ON and will not connect at all. Any way of unbricking it?
Thread: Bricked my X2 III
Results 1 to 10 of 43
-
Bricked my X2 III – 07-17-2015,04:16 PM
-
07-17-2015,04:29 PM
Same like my X2 premium .Its stay "ON'. ,and nothing on the tv/ black screen/ , The lighting hit it ..
Last edited by chifut; 07-17-2015 at 04:30 PM. Reason: '
-
07-17-2015,05:49 PMX2 Premium III HD, Openbox X5/ S10, Gsky V3/V6, iSmart m100
-
07-17-2015,06:22 PM
I didn't check them ,but I guess my 4x1 switch and the LNB are blown up also . I did had the same problem back in the years . .
-
07-18-2015,05:45 AM
Thanks Carlos, I will give it a shot. I haven't flashed a file this way in at least 8 years. I do have cables but not quite sure which is null modem and I would have to start up my extremely old laptop which has the 9 pin port to accomodate the cable.
-
07-18-2015,09:04 AM
Most RS232 cables provided inside FTA boxes are Null. Straight cable is rare and use in limited models. So if your came inside of any model most be Null. Once you set your Com computer its a pretty easy process to do. Good Luck!
X2 Premium III HD, Openbox X5/ S10, Gsky V3/V6, iSmart m100
-
07-18-2015,10:31 AM
I used to do this very often but I haven't in many years. I will power up my old dinosaur laptop later and attempt a recovery.
-
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Kiss My Assmadmadworld liked this post
-
07-18-2015,03:13 PM
Unbelievable....I did a fw upgrade via the internet and it's bricked again. The tv screen says Strong, not Premium III. I am going to transfer the latest file via null modem cable and hope to bring this stb back to life again.
-
07-18-2015,03:15 PM
Something is happening lately with X2 though!
X2 Premium III HD, Openbox X5/ S10, Gsky V3/V6, iSmart m100