It happens only when try to move the dish to E. When the message is displayed, asc can move the dish to the W, but not E. When pressing the E button, there is NO click (sound) from the relay. Sometimes after few W commands, the E movement is restored !!! I suspect the head from the transf may have an impact also, as the top of the casing in that area is always warm (hot). Brian suggest to install some ferrite rings on the wires for the motor sensor (as in the pic), witch I did but the problem still pop up:
[Only registered and activated users can see links. ]
The actuator was replaced 1.5 years ago, after i considered that the first 12 years old, needed to get a rest.
Results 1 to 10 of 62
Hybrid View
-
03-04-2024,11:16 AMNihil sine Deo !
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Kiss My Assel bandido liked this post