Anybody have a bluetooth keyboard?
The OS Mini is advertised to be bluetooth capable, but I know speakers are excluded. There is a bluetooth plugin available in most OE Alliance images such as OpenATV and OpenVix. The bluetooth plugin is not available yet in SatDreamGr images.
Results 71 to 80 of 118
-
09-30-2016,01:48 PM
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssViP3R thanked for this post
-
-
10-26-2016,11:52 PM
I am very happy with the Montage 6000 tuner. The snr values of the 6000 are about equal to the TBS5925 using EBSPro. The TBS5925 is about 1db less than the Montage 6000 when the TBS5925 is used as an external usb tuner on the OS Mini. The Sundtek Sky ultimate V DVB-S2 usb tuner performs a tad bit better than the TBS5925, but the Sundtek tuner is also behind the Montage 6000 tuner. All of these comparisons were made using the 16APSK mux at 97W. I would think the internal tuner may have a slight advantage due to it being internal, instead of having the extra loss in lines of an external tuner.,
I have been using the OS mini to set my new 3.6 meter dish. e Montage 6000 blindscans decent, but will miss transponders below about 1600SR. The Montage tuner can receive manually entered transponders down to about 1,000SR. Blindscan speeds for satellite scans vary. Most blindscans take 5-10 minutes, but some may take quite a bit longer than that. Enigma2 has always been slow to scan the found transponders. The blindscan for the transponders is pretty quick. The scan for channels is what eats up the time.
Attached are a couple of screenshots taken from the signal finder plugin. I think the signal level is very good, considering a cheap consumer lnbf is being used.
[Only registered and activated users can see links. ] [Only registered and activated users can see links. ]
-
Post Thanks / Like - 3 Thanks, 0 Likes, 0 Kiss My Ass
-
10-30-2016,06:00 PM
OpenPLi and SatDreamGR will be adding channel names to their images. This is a big improvement over channel frequencies. ATSC transponder time is also available and is accurate on the frequencies I have tested.
These screenshots were made using the Hauppauge 850 ATSC USB Tuner.
[Only registered and activated users can see links. ]
[Only registered and activated users can see links. ]
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 Kiss My Ass
-
10-30-2016,08:37 PM
Nice improvement... would be nice if they could figure out an epg too. Any idea if Satdreamgr will be able to update the flash via the internet similar to the Betacentauri updater in BH? I found SDG Vu+ ImageDownloader plugin, but it won't update the flash plus restore settings.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssViP3R thanked for this post
-
10-30-2016,10:06 PM
I have always been able to update the flash in SatDreamGR via the Internet. Use::Menu--->Setup--->Software Management--->Software update. Always a good idea to backup the image or at least the settings before updating.
.
.
.
Meine Dreambox One ist ein Stück Scheiße!.
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 Kiss My Ass
-
10-30-2016,10:57 PM
I guess I missed that one.... will give it a shot tomorrow.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssViP3R thanked for this post
-
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 Kiss My Assel bandido, rodder thanked for this post
-
10-31-2016,05:40 PM
I can't remember exactly which Technomate this is a O.E.M of but it will run the same image. You just need to rename the initial folder. So any E2 image for their Technomate counterpart will work on the Edison OS version. Including ViX who did build but withheld images for the Edison Optimus OS boxes.
Last edited by Pale-Rider; 10-31-2016 at 05:49 PM.
-
Post Thanks / Like - 3 Thanks, 0 Likes, 0 Kiss My Ass
-
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssViP3R thanked for this post