Anyone know where to find parts for an old VonWeise 24 inch actuator???????
Here are some photos of the back end inside.
[Only registered and activated users can see links. ]
I need the white cams and the black sensor.
The white cams are the East West limit settings, it has crumbled to dust.
And I think the sensor has gone bad as it jumps around instead of a smooth East West movement.
Thread: Parts needed
Results 1 to 4 of 4
-
Parts needed – 07-26-2016,11:32 AM
-
07-26-2016,08:10 PM
If you can post a better picture of the sensor we can get some numbers off of it to try to find something that will work. As far as the limit switches I took mine out of my actuator and just set the limits in my 4dtv.
I am thinking that a 3d printer could probably make the new cams though.Portable Comtech 13', Winegard 10', SAMI 7.5', 3 39" Ku dishes one motorized. Scanning 30w-131w
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssTerryl thanked for this post
-
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assrrob311 thanked for this post
-