Gekko Test and Review

[el bandido]

Good to know it works!

I think 60 Degrees for USALS has been the standard for years. The only explanation I would have is the table for USALS has been expanded

[Jim S.]

I tried the new 2.10.57 software today. Blind scan seems to be a tiny bit faster on certain satellites, but I didn't actually time it, so it may be my imagination after reading the Raptor 2.10.57 thread LOL.

The thing that really jumped out at me, though, is the quality meter. The dynamic range seems to have improved a lot. Strong signals read higher than before, BUT weak signals read lower than before. I like it! I have not, however, tested the expanded meter view on the aiming screen, to see if anything changed with the response speed and smoothness that I complained about earlier in this thread.

[Kosme]

Hi, I tried the new 2.10.57 software today too. But have a question - how to activate RSS reader to open live web news. When i typed rss-url, the reciever display me:
"This url has unsupported protocol"! How the correct this error?
Thank you!
Best regards!

[ViP3R]

Hi, I tried the new 2.10.57 software today too. But have a question - how to activate RSS reader to open live web news. When i typed rss-url, the reciever display me:
"This url has unsupported protocol"! How the correct this error?
Thank you!
Best regards!

Hello, I have not tried the rss feeds on the Anaconda yet, they should be just the same as the Gekko..

Just a c\p I found that may help?

RSS has a standard syntax of [Only registered and activated users can see links. ] ... site ....also the site must support RSS feed .

It may be easier to load an url list of RSS feeds through USB , I will look into this and see what I can find.

[Kosme]

Hi, the error was [Only registered and activated users can see links. ] wrong write URL!
All RSS work fine !
Thanks for attention!

[hagencampos]

Good morning
Has anyone figured out how to BACK-UP what I have in the receiver ? Just in case....I mean firmware + plugins
Thanks in advance for yr help.

[hagencampos]

Another question.
Can I use a null modem cable to transfer all contents in a Optibox Gekko to another Gekko receiver?. And How do it, please?