Vu+Zero Help

[Costactc]

All right enigma 2 gents I need to know which file to flash my new vu+zero. I'm going to do the main setup and have a look.

[el bandido]

Try the Open PLi Image. Any of the images that are designed for the Zero will work.
You should also install FileZilla on your computer so you can transfer files to the Zero through your local network.

[eastof111]

Costa, the only differences you will find in the images are the flexibility offered in plugins (some may show up in the plugins section available for download and some that will work only with certain images), skins, gui layout, etc. Your choice, best to try them one at a time until you find the one you like.

You might check for a multiboot option (don't know if it's available for the Zero. Usually embedded into the image or available as a plugin. This will allow you to keep x number of images on your hard drive or usb stick that you can select from a menu to boot up and not have to flash every time you decide to change an image. Very nice option for testing purposes.

[Costactc]

I can't get the zero to communicate with my tv in the living room, it works fine in the basement. I have set it to 720p which works great in the basement and 1080i which is a bit shifty. I've attempted with the other and get no sync signal.

[eastof111]

Did you set it for 60 hz?

[Costactc]

No, just 720p and 1080i. I'll take it downstairs again and have a look.

[Costactc]

Finally. 60hz did the job, strange that it worked fine on my other tv.

[Costactc]

Any way to load a NA satellite list? This receiver is a bit complicated, looking forward to the challenge. I have downloaded filezilla and I'm going to attempt to flash Black Hole file but not quite sure how that will go. I have it on 1080i English NHK channel on 58w, picture quality is spot on.

[el bandido]

You may use my satellite file. First, See if you can connect to the receiver using FileZilla You will need to access the network in your receiver to see what ip has been assigned to your local network, then enter the receiver's ip into FileZilla and try to connect. The login or username and the password for the box should be root root.

[Costactc]

I got Black Hole on my vu+zero and it's real cool. I am going to attempt to connect with filezilla.