Enigma2 and ku blindscan in NA

[eastof111]

Nice!! Will check it out with various images as time permits. I must say you are being very gratuitous to Vu+ for their blind scan BS. But what the heck, they do produce quality receivers.

[el bandido]

Vu+ Has nothing to do with this. This is not a Vu+ specific blindscan plugin.

[eastof111]

EB, had a chance to load it to ATV and Openspa so far, but keep getting the getboxtype error.

[el bandido]

Will be glad to modify one for you that will work on those images later....
My idea is to test it and turn it in. If it gets accepted then it will probably end up in many different images over time. Please check it with what it is designed to run with which is OpenPLi or SatDreamGr. If it works OK, then I will see if it can be added to their blindscan plugin.

[eastof111]

Thanks, sounds like a good plan.

[eastof111]

Installed latest Satdreamgr 20160812 and scanned 125 ku with 14 channels showing up. Scanned 97 ku and 288 channels displayed.

Copied and over wrote systemplugins blindscan ygit-4368+713b164-r24 with your blindscan and got the same results after scanning 125 and 97.

Rebooted to ATV in multiboot and scanned 125 and 97 with your blindscan-na and again, got the same results.

No hiccups so far.

[el bandido]

Are the correct frequencies being displayed? Sounds like it is working correctly.

[eastof111]

I was happy that the blind scan worked. I got used to the fact that some channels will display the frequencies correctly while on other sats they do not. Still a hit or miss in that regard. I've always gone in to the information menu and hit the multiplex button to get the correct frequency. If this can be remedied, it would be an additional bonus.

[eastof111]

Here;s another jpg using the latest Satdreamgr. The post above was with ATV and blindscan-na.

[el bandido]

I was happy that the blind scan worked. I got used to the fact that some channels will display the frequencies correctly while on other sats they do not. Still a hit or miss in that regard. I've always gone in to the information menu and hit the multiplex button to get the correct frequency. If this can be remedied, it would be an additional bonus.

Menu--->Setup---User Interface
Change Infobar frontend data source. If it is on settings, change it to tuner. If it is on Tuner, change it to settings. Reboot box.