X2-Premium-Special-Edition

[ftanut]

Using the April 9, 2013 software as noted earlier. Tried to a couple of times to set the "Date and Time", but later I noticed that it reverts to a random and oddball time and date. Has anyone else noticed this happening, or is it just me doing something wrong in the time setting procedure.

carlospr43 mentioned and had an attachment for the Satellite and channel list for the USA folks, is that the Satellite and channel list already built into the April 9 revision or is that a different list. Always asking questions and learning at the same time LOL!!!

Thanks.
,

[el bandido]

Morning EB

I have a copy for the April 9 firmware but I havent load it yet because it wasnt never released from X2 eventhough some models have being received with the version in it. If you or Viper give me the go ahead I'll do it

I do not see anything wrong with posting it because newer receivers are being shipped with it. Go ahead and post it so others can try it.

[cpr43]

Done!! File available at the files section!

[dsmitrh0429]

Other than the case design, is there a difference between the X2 Premium and the Premium II? My premium II will no longer start up past the X2 logo screen, and I tried using the bootloader posted here and it still will not boot.

[cpr43]

Other than the case design, is there a difference between the X2 Premium and the Premium II? My premium II will no longer start up past the X2 logo screen, and I tried using the bootloader posted here and it still will not boot.

Both models used different chips, different firmwares etc. They are a completely different boxes. If using the correct bootloader for the PII make sure no cable is connected it to the box (HDMI, RCA or ethernet). Only the null cable to your PC and the right file (326sz_v33_1024.r1689.flash.gz.gro.stp). Sometimes it tooked me several attempts to make it. If time out screen show up you need to start all over again.

[dr.zin]

as long as the receiver boots the rs232 method should work fine

[Costactc]

I haven't flashed a file to my X2 in quite some time, just wondering what way to do it. I don't want to brick it like I did my III.

[cpr43]

Fine to update with latest file using the USB method

[Толькі зарэгістраваныя і актываваныя карыстальнікі могуць праглядаць спасылкі. ]

[Costactc]

Fine to update with latest file using the USB method

[Толькі зарэгістраваныя і актываваныя карыстальнікі могуць праглядаць спасылкі. ]

Thanks Carlos but I meant from usb do I flash as all code?

[cpr43]

Use all code & boot code