I thought the backup worked well but I only realised now that if you perform a backup it will also flash the same file that you had working with the receiver. Although most of the internet functions are working spot on, I will need to flash the new sw and start all over again.
Thread: FW Upgrade by Internet?
Results 11 to 13 of 13
-
09-26-2014,07:29 AM
-
09-26-2014,08:25 AM
Morning Costa,
To restore the channel list only and not the old software read below..you won't have to start over.
1-Attach USB Flash to receiver
2-Make Software Backup as Following
Menu - External Device - Upgrade By USB - Backup - Start
3-To Restore the Channel list please make the following
Menu - External Device - Upgrade By USB - Backup ( Press Left on Upgrade Mode and change into ( Userdb )
Then press Start and wait till the receiver make restart automatic .
After Restart all the channel list will restore on the receiver.
Also there is a new Sept 26 file available through FTP. I will upload it also.
click click b00m
-
09-26-2014,12:17 PM
Upgraded to the September 26 file and loaded all my info and it retained the latest file, worked like a charm. However, the last thing you need to do when reloading your backup is:
upgrade mode userdb
upgrade file backup.abs
start
You cannot go left or right in the upgrade file area.