Openbox S10 will not turn on

[rrob311]

So the box will probably be OK? It's like brand new. I am not impressed with the quality of this as opposed to the S9.

[cpr43]

just stick to the post and follow the .pdf instructions

[rrob311]

Well I was able to scrounge up a serial cable in a Viewsat box and load a file so now I have LEDs and I guess it works. Thank you everyone for holding my hand with this as I have never recovered a box using old school serial method. Thanks again!

[cpr43]

[rrob311]

The receiver is working OK but I scanned in everything on 91w Cband and when I switch to different channels, mainly dvb-s2 the box resets itself. Has anyone ran into this? What firmware is the most stable for this? I am using the one that was shown in the thread earlier.

[cpr43]

Make a copy of your sats/tps/channles (TP_prog) . Turn off the box in the rear switch. Unplug the coax cable. Turn on the box. If you really want a freeze/lockup free firmware use 07/14/2011. Give it a try. Eventhough it is named 07/19/2011 when you unrar the file is 07/14/2011. Once you load the firm, load your TP dump file. Turn off the box in the rear switch. Connect back the coax cable and turn on the box. See how it works, Good luck

[Only registered and activated users can see links. ]

[rrob311]

I I keep getting an upgrade file is mismatch error when I try to upgrade via usb.

[rrob311]

OK I switched from my 16gb bmw usb drive and back to my cruzer 4gb and it is working fine so I guess it didn't like the 16gb drive.

[el bandido]

Reload the file again through the rs232 port.