Sat list for Amiko

[lme]

Try to load VIP3R list into the box, but it is not accepted !
It is not recognized by Dog program either.
Using Dog soft started to create my own list but can't input decimal number for sat (93.1, 107.3, etc).
any help ?
thx.

[el bandido]

I had a problem with the decimals too.
Are you using a motor? What satellites do you need on the sat file?

[ViP3R]

Yes, the dogsettings editor does not like the spark list once edited..even when set to spark as opposed to enigma2. in fact it will delete the file you just created.

I have been experimenting with a free hex editor. you can change longitude, and decimal points..I made one change just to test and it was successful.

Still experimenting with this, but I think It will do everything we need, just time consuming to do. otherwise I would have a file ready now.

You can download it here> [Only registered and activated users can see links. ]

[ViP3R]

Try to load VIP3R list into the box, but it is not accepted !
It is not recognized by Dog program either.
Using Dog soft started to create my own list but can't input decimal number for sat (93.1, 107.3, etc).
any help ?
thx.

In the mean time if you like I will download my list right from the box and you can load it. Save a backup of your own first so you can go back if needed.

Send me a pm with your email and I will send if you want it..

[lme]

I'm scanning every sat from 30w to 121w with a motorized dish.
PM sent. thanks.

[el bandido]

c band or ku? Are you using USALS or diseqc1.2

Two things to remember about the satellite file in Spark. (1) Use a Kingston usb drive. I tried using a SanDisk and I could not get the receiver to accept it. (2) Do not put the files in a folder. There will be about 5 files that are created in a Spark sat file. These files must be put on the disc without using a folder.

Please upload a sat file that you were using in your old receiver.

[lme]

Using USALS for ku for now. later a c band.
using an 8gb kingston stick with all 5 files on it. did not accepted any XML file but mine (partially edited with dog).

[ViP3R]

Using USALS for ku for now. later a c band.
using an 8gb kingston stick with all 5 files on it. did not accepted any XML file but mine (partially edited with dog).

Did you load the list I sent you.

[lme]

No, I did not.
Look at it with dog and is what i have done. 107.3w is listed as 107.0w
I'm stuck at entering decimals: 111.1, 118.7, etc

[el bandido]

What size is your dish?