Factory test menu,
menu,information,11111
rs232 test choice tests the rs232 is receiving and you are using the correct cable.
Use a terminal program on the pc and type away.
Good for rookies that never loaded via rs232 before to verify everything.
Tested on old firmware,should be the same results with newer.
Thread: got rs232?
Results 1 to 3 of 3
-
got rs232? – 01-22-2012,06:07 PM
-
01-22-2012,06:11 PM
I thought I would need a loopback connector,that was a lot easier.
I already used a terminal program to verify the rs232 was alive by the "app init ok" message.
I see lots of people on other forums that attempt to load with the wrong cable.
But it works on my "bla bla" receiver.
Naturally this must be done on a good working receiver first.or am I being obtuse?
-
01-22-2012,06:30 PM
A quicky test without a terminal program is start the test then start the loader.
The loader sends cccccccccccc to make contact with the receiver,you will see a few c
on the rs232 test screen when the test ends.Verified working with the latest firmware.
c
cor am I being obtuse?