New Motor

[Guest]

I noticed that my VonWeise motor was a bit rusted so, with the help of my neighbour, I swapped it out for a refurbished VonWeise. I had to reset my limits on my positioner and have been restoring my sats:


[Only registered and activated users can see links. ]

[ViP3R]

Nice Costa, very time consuming is it not..

[Guest]

With the help of my neighbour it would have only taken about 1/2 hour. We decided to test it out on the right side instead of the left side that I have the motor on now. We decided to leave it on the left side because I couldn't get the dish down to 11w on the right side. Still programming my positioner, I'm on Amc 9 at 83w at the moment. Good job of posting those c band feeds Viper.

[ViP3R]

Get it set up yet bro...

[Guest]

All set up and ready to go, looking forward to future feed posts. Starting to feel alot more comfortable Viper. So this is for you, fok you Viper. Looking forward to a great future for this site.

[ViP3R]

Nice... this is for you then.....

[Guest]

37 c band sat positions programmed into the Pansat AP3500 positioner, all sats from 11-127w