Well dammit. Did it before. Now I have a brick. Help maybe?
My splash was openatv. Was for a long time. Tried to flash the Edision spalsh (just when the osmio4k boots).
After. It stuck on 50% booting like forever. I cut the power to it, pulled the USB. Plugged it back in.
Nothing. Blank screen. But something appears to be going on inside because the IR blaster lights up for a few seconds and my ASC1 display comes on until it times out.
Couldn't happen at a better time, huh!
Read around hear and there. Mainly here for an unbrick.
Tips from you EB on a serial, RS232 recovery. Yeah I plugged it in and hit the menu key on the remote rapidly. No joy.
May I say....CRAP!
Is there a method to try using the serial port. I didn't crack the receiver open to see if there is a pinout silkscreened. Is it a 3 pin port? Rx/Tx/Gnd?
If there is a way to try to bring life back in this critter. Is there a pinout available? And a guide to flash what I guess would be the bootloader? I have that on a stick ready to go.
That is if I can get a terminal at least connected. Baud rates, etc?
Unbelievable.