TNAP-5 Image Discussion

[cyberham]

The multi-satellite scan function located under Manual scan should work. Do an online update again and recheck.

Today's online update also sends the correct bootlogo and corrects the drivers being listed twice in feeds.

I updated. The multi-satellite scan is working.

I notice something interesting. This occurred with new TNAP 5.1 even before today's update. If I use Positioner Setup to fine tune the dish with diseqc commands, save and exit, then if I change channels while still on the same satellite, the box crashes every time. My workaround is to exit Positioner Setup then change to an adjacent satellite. If I then move back to original satellite, the box doesn't crash.

[el bandido]

Need to see the crash file as this should not happen!
Thanks.

[cyberham]

It stopped crashing. Maybe it only occurred on the first time I did each satellite. I will monitor.

[cyberham]

Need to see the crash file as this should not happen!
Thanks.

This just happened so I grabbed the crash log.
[Only registered and activated users can see links. ]

[el bandido]

This just happened so I grabbed the crash log.
[Only registered and activated users can see links. ]

[eServiceMP3] Gstreamer error: Could not establish connection to server. (5) from source
[eServiceMP3] Gstreamer error: Internal data stream error. (1) from source
[eServiceMP3] Gstreamer error: Stream doesn't contain enough data. (4) from typefindelement2


Can you post your channel file named lamedb? This file is located in /etc/enigma2.
Thanks.

[cyberham]

[B]...Can you post your channel file named lamedb? This file is located in /etc/enigma2....

Recently when changing between images, I did ftp my backed-up lamedb and other user files to the Mio+. I just didn't want to lose all my C-band scans, etc. I bet you're going to say my lamedb is corrupted in some way. I always dislike doing this since it seems this causes trouble.

I just updated my Mio+ online, then I grabbed a copy of my current lamedb (attached). I renamed it .txt just so I could transfer it.

[el bandido]

Updates are online that should solve most of the signal finder errors. These errors or complaints did not seem to bother anything, so I doubt fixing them helped. The Gstreamer error is what I find interesting. Why is a "Could not establish connection to server" error in there unless some type of ip issue is present? Anyway, do an online update and see what happens.

[cyberham]

...Anyway, do an online update and see what happens.

Same symptom even after I updated. After exiting Positioner Setup, the display shows as attached. Note how Tuners A and C letters are not green. The Mio+ has always done this. So I must press the Up key to change channels to make the Mio+ "see" the channel even when there is only one channel scanned in such as on 129W Ku. But when I do this, the box crashes. If I press the Right or Left key to change satellites, then go back to the satellite, the box doesn't crash. This simple workaround isn't so bad at least until TNAP5.1 comes along when I won't restore user files; just create them fresh at that time maybe with exception of user bouquets which are a lot of work to re-create.

[Only registered and activated users can see links. ]

[el bandido]

Look at the bottom of the lamedb. That don't look right at alll.....

[Only registered and activated users can see links. ]

[el bandido]

Do you select yes and press the ok button when exiting Positioner setup?

[Only registered and activated users can see links. ]