Seems like you have asked this before, and in a way, I am not sure what you are really asking because you do not show what resolution your receiver outputs for these channels.
The Octagon SF-4008 is not on the same level as a cheap ($100.00 or less) Android 4K box.
Here is a screenshot of the Masters 4K feed. Maybe it will answer your question?
[Only registered and activated users can see links. ]
Octagon is not going to produce a 4K receiver that is not capable of 4k output! It would be suicide for them to do something such as that.
Let me know if this does not answer your question and I will try something else.
Results 31 to 40 of 282
-
04-11-2017,08:44 PM
-
Post Thanks / Like - 4 Thanks, 0 Likes, 0 Kiss My Ass
-
04-11-2017,09:37 PM
8.5 db on 97w? Seems rather low for the size dish you have. I know owners on the other sites were reacting to low or high db readings for over a month. So, I am guessing this is still on Octagons to do list. Will be interesting to see later what the actual db display for 4k should be.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assmountaineer thanked for this post
-
04-11-2017,09:56 PM
IMO, the db in snr seems to be ok and is comparable to the oS Mini. That particular feed was not very strong for me. Also, at some point, I probably need to invest in a commercial lnb arrangement. I feel certain that i will pick p some things a bit better if I upgrade from a cheap lnbf to a commercial lnb.
A lot has been said about pll lnbs in fta forums, but I have seen no advatage using a consumer pll lnb. The pll oscillator generates more noise than a dro oscillator, so the pll oscillator requires extra filtering. More filters may bring a better signal to noise ratio or snr in db. Either a good commercial dro or a good commercial pll lnb may help my antenna system a bit. Any lnbf is only for the consumer.
-
Post Thanks / Like - 3 Thanks, 0 Likes, 0 Kiss My Ass
-
04-12-2017,06:13 AM
Yes, your post clearly shows the resolution, thanks. I am pretty sure when I asked before you did not possess this receiver. At this point I am curious as to what people think of the resolution difference between 1080p and actual 4k with this receiver.
Portable Comtech 13', Winegard 10', SAMI 7.5', 3 39" Ku dishes one motorized. Scanning 30w-131w
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Kiss My Assmountaineer thanked for this postmountaineer liked this post
-
04-12-2017,06:29 AM
I do not have a 4K television or monitor yet, but no one has complained about the 4k quality on any European forum that I have seen. Why not purchase one and see for yourself? These receivers do not cost a lot of money.
.
.
.
Meine Dreambox One ist ein Stück Scheiße!.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assmountaineer thanked for this post
-
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assmountaineer thanked for this post
-
04-16-2017,11:22 AM
The time frame for Kodi to be released seems to be "Sometime before the end of April". I doubt anything else gets fixed until Kodi is finished.
Most of the usb tuners that I have tried to use with the Octagon either do not work, or only partially work.
Blindscan for DVB-S/S2 is not supposed to be released until after Kodi is finished.
I have more or less put this receiver on the shelf. It is pretty much useless for me the way it is now except to watch some 4K or UHD on rare or special occasions.
Personally, I think they should have fixed some of the other issues first instead of getting bogged down with Kodi. Then again,Kodi is not much use to me.
-
Post Thanks / Like - 3 Thanks, 0 Likes, 0 Kiss My Ass
-
04-16-2017,01:48 PM
I guess the SF4018 will most likely not be released until most items are corrected and working properly on the SF4008. Wouldn't make sense to release an upgraded receiver when the lesser one is still not perfected. But, stranger things have happened.
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Kiss My Assskink thanked for this postel bandido liked this post
-
04-16-2017,02:21 PM
I think these guys ran into some problems they were not expecting to have. I do not regret buying the box, and more or less expect things not to work correctly or at all in a newly released receiver. I did expect them to have more done in this amount of time though. At any rate, the finished product will speak for itself - Whatever the finished product is...
-
Post Thanks / Like - 4 Thanks, 0 Likes, 0 Kiss My Ass
-
04-17-2017,08:53 AM
Well, Let's have some patience, maybe be we will have blind Scan in a few months, I still waiting for my box, it got lost, hopefully Satshop.Fi can send me a new box or return my money.
Regards.
Chewie
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 Kiss My Assel bandido, eastof111 thanked for this post