Results 1 to 2 of 2
  1. Collapse Details
    More switch questions.
    #1
    Join Date
    Jun 2013
    Posts
    100
    Post Thanks / Like
    Contribute If you enjoy reading the
    content here, click the below
    image to support our site.
    Click Here To Contribute To Our Site
    I was successful in setting up three LNBs on my 1.2 meter Ku dish, using a DiSecq 4x1. Right now my setup is as follows: DiSeqc at 1.2m dish, 97W at position 1, 95W at pos. 2, 103W at pos.4, 30W lnb is located on my 1m dish and using pos.3 of the DiSeqc switch. Everything is working fine with this setup, and all channels are coming in at about 70+ %.

    Now, I am trying to get my "C" Satellite dish interfaced in this setup. In other words, I would like to use the same Diseqc switch with both dishes (Ku, and C). Tried a 22mhz switch inline with the Diseqc, but only the C band side works. Have the Ku side to the On post of the 22mhz, and the C side to the 0 post.

    What would be the Diseqc designated command, and for the 22mhz switch, when using the above setup and the X2 Premium HD receiver.

    Thank You.
    Reply With Quote
     

  2. Collapse Details
    #2
    Join Date
    Feb 2011
    Posts
    241
    Post Thanks / Like
    Tried the same setup, just to realize that X2 is not working with it, but any other stb does !!!
    Read about X2 not playing well with Ecoda type switch and Diseqc 1.2 motor setup.
    Nihil sine Deo !
    Reply With Quote
     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •