Results 1 to 8 of 8
  1. Collapse Details
    VonWeise 24 inch actuator
    #1
    Join Date
    May 2016
    Posts
    155
    Post Thanks / Like
    Contribute If you enjoy reading the
    content here, click the below
    image to support our site.
    Click Here To Contribute To Our Site
    Anyone have a parts layout diagram for a 24 inch VonWeise actuator?

    Mine went FUBAR and I need to see what I am up against if I try and repair it my self, 200 smackers for a new one is a bit outside my budget right now.

    But replacing the limit switch actuators (they fell apart) and the micro switch is not.
    Reply With Quote
     

  2. Thanks Costactc thanked for this post
  3. Collapse Details
    #2
    Join Date
    Dec 2012
    Posts
    9,278
    Post Thanks / Like
    Although I am using 2 VonWeisse jacks at the moment I do not have any specs on them at all.
    Reply With Quote
     

  4. Collapse Details
    #3
    Join Date
    May 2016
    Posts
    155
    Post Thanks / Like
    Darn...And I can't fine any listed on-line ether.

    I sent an E-mail to the company to see what they have.
    Reply With Quote
     

  5. Collapse Details
    #4
    Join Date
    Dec 2010
    Location
    Calgary, AB
    Posts
    13,910
    Post Thanks / Like
    I grabbed this off the net..hope it helps.

    [Only registered and activated users can see links. ]

    click click b00m
    Reply With Quote
     

  6. Thanks Costactc thanked for this post
  7. Collapse Details
    #5
    Join Date
    May 2016
    Posts
    155
    Post Thanks / Like
    Thanks, I have seen that one, I think mine is an earlier model as my limit switch cams do not have the two set screws as shown in that drawing.

    And the internal lay out is a bit different, I will try to go take a photo, that may help.
    Reply With Quote
     

  8. Thanks ViP3R thanked for this post
  9. Collapse Details
    #6
    Join Date
    Dec 2010
    Location
    Calgary, AB
    Posts
    13,910
    Post Thanks / Like
    Quote Originally Posted by Terryl View Post
    Thanks, I have seen that one, I think mine is an earlier model as my limit switch cams do not have the two set screws as shown in that drawing.

    And the internal lay out is a bit different, I will try to go take a photo, that may help.
    I see.. bummer, well hopefully VonWeisse will send you something, they seem a pretty good company.

    click click b00m
    Reply With Quote
     

  10. Collapse Details
    #7
    Join Date
    May 2016
    Posts
    155
    Post Thanks / Like
    Here are a few photos.
    [Only registered and activated users can see links. ]
    [Only registered and activated users can see links. ]
    [Only registered and activated users can see links. ]

    The last one shows the cam that has the center part crumbling apart.

    But it's for the East/West limit switches, the problem I think may be the little square black item in the top photo, that may be the sensor I need.
    Reply With Quote
     

  11. Collapse Details
    #8
    Join Date
    May 2016
    Posts
    155
    Post Thanks / Like
    This is the little black square thingy that may be the sensor that is FUBAR.

    [Only registered and activated users can see links. ]
    Reply With Quote
     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •