Just noticed that even when a single satellite is selected the channel numbering reflects the numbering system as if I were viewing the all satellite mode.for example I rescanned two satellites 125.0 KU with 13 channels and 123.0 Ku with 7 channels when I select 125 I list channels 1-13, Then when I go to 123.0 the channels are listed as 14-20 instead of 1-7. Just wondering if anyone has had this problem. I haven't found any settings that have any effect. I tried doing a factory reset and reinstalling the firmware but no good. If anybody has any Ideas I would appreciate it.
Thanks in advance....