Try the attached file and see how it works. Several changes have been made, so check it and verify that it scans and works to your satisfaction.
Standard lnb start frequency is 11550. You have to do this because the 10600 lnb l.o. frequency is 150 MHz less than the target 10750 l.o. (11700 - 150 = 11550). This is something I will try to fix in the cleanup.
11250 and other lnb l.o. frequencies could also be added if there was a need...
Thread: Enigma2 and ku blindscan in NA
Results 61 to 70 of 310
-
05-19-2015,09:45 PM.
.
.
Meine Dreambox One ist ein Stück Scheiße!.
-
05-19-2015,10:10 PM
Will give it a shot tomorrow afternoon.
-
05-19-2015,11:34 PM
This is a great development and my hats-off to the code writers for their efforts. I will test this asap.
-
05-20-2015,04:53 AM
Hello & Welcome to Legit!
What receiver are you testing this on? Please provide make/model..
.
.
Meine Dreambox One ist ein Stück Scheiße!.
-
05-20-2015,07:19 AM
Looking at adding an option to where the .xml is stored: Either in the receiver's /tmp folder or a mounted hard drive.
[Only registered and activated users can see links. ]
I do not think a bunch of options is a good idea because it causes clutter and confusion for the operator. But problems or issues will occur if you tell it to save the .xml to a hard drive and no hard drive is available.
-
05-20-2015,10:57 AM
If it's saved as a tmp file, Filezilla is your friend. If it's saved to a usb stick, it might still pose a crash problem, should one forget to plug in the usb stick. An auto search routine would solve that problem by not trying to save to usb or hdd if one is not found.
True, too many options would cause confusion. It's hard enough to find certain options in the system menus as it is now.
-
05-20-2015,02:25 PM
Still using ATV 4.2 latest build in open multiboot with Vix in flash....
Here are a few things I tried with reboots after each install.
Installed blindscan over old and it would not compile.
Deleted blindscan and installed new version again, still would not compile.
Deleted satscan and blindscan and installed new blindscan and still won't compile.
The blindscan folder actually disappears after a reboot. Also, the old blindscan had a folder name locale which the new blindscan does not.
Added the locale folder to the new version and installed, rebooted and blindscan
does not display in search menu, but this time the blindscan folder is intact on drive.
I went back to the old version of blindscan and satscan_10750
and everything is fine again.
-
05-20-2015,02:30 PM
I can change the version, but that particular build is for OpenPLi. Try loading it on that image and see what happens.
-
05-20-2015,02:37 PM
I'll have to flash it cause it doesn't like multiboot.... so, it might be a while.
-