I have tested file EB (post 155) and I have followed instructions.
I did transfer the file via dcc295 (dream control center).
I am using VU+solo HD SE with Vix apollo 166 image
125 Amc21 satellite scanned with blind scan and works
using lnb ku linear std
I did not touch any setting..
Just couple of Tps. missing mainly symbol rate 4444 but I did manual scan
[Only registered and activated users can see links. ][Only registered and activated users can see links. ][Only registered and activated users can see links. ][Only registered and activated users can see links. ]
Thread: Enigma2 and ku blindscan in NA
Results 201 to 210 of 310
-
06-05-2015,07:41 PM
Last edited by bronco; 06-05-2015 at 09:16 PM.
-
06-06-2015,02:52 AM
Just tested Blindscan_EB from Post #155 with OpenATV 5.0, Kernel 3.92 on 103.0°W KU and it works. I will test C-Band later.
-
06-06-2015,08:43 AM
Excellent! It looks like work on this plugin is almost finished.
I am glad to see some use of this plugin.
Now to tidy up and complete the plugin.
If the default c and ku start/stop settings are ok, then they will stay as they are.
An error message will be added when a User Defined lnb is selected. That is what I am working on now.
User Defined lnb Probably could be used for c-band bandstacked lnbs, but I see no reason to add that because there are no users wanting it.
-
06-06-2015,10:14 AM
This plugin may also be used to scan the same satellite on different bands.
Every enigma2 c/ku blindscan plugin that I have seen checks for transponder type in the satellite file. The type of scan is based partly on the stored transponder information.
This transponder check has been removed from this plugin, and blindscan type is based only on LOF type. Doing this allows blindscanning of different bands under the same satellite name. So it is possible to have only one c/ku satellite entry per orbit location instead of two per orbit location (1 for C and 1 for Ku).
I tested this c/ku combination on 103W and it works without any issues. I have separate motorized dishes for the c and ku bands. The dish for a particular band does not move until a channel is selected for that band. The c/ku combination works very well for me. I plan to eliminate the separate c/ku satellites and just have one entry for each orbit location.Last edited by el bandido; 06-06-2015 at 10:32 AM.
-
06-06-2015,04:44 PM
I have one question.. After installed EB blindscan I saw that original Blind scan from the Image is erased.. Is possible to keep both Blind scans (EB & original from Image) ? just to compare both..
thanks
-
06-06-2015,06:03 PM
Yes, it is possible to keep both, I will see about that if you want it that way. There is really no need for that because this plugin has the same stuff as the other blindscan plugins. These plugins do not control the actual scans, so they are nothing more than an interface for the scans.
-
-
-
-