Enigma2 and ku blindscan in NA

[el bandido]

Lots of times, the crash log will tell you what the problem is and where to look for it:

AttributeError: 'module' object has no attribute 'getImageTypeString'

Worked fine for me in PLi....lol
At any rate, that error should be fixed now in the attached file.

[el bandido]

The first scan with start frequency of 11700 and a yes to 10750 lnb gave me no transponders found display.

These are the only settings you should use. They work fine for me, and I think we can make them work fine for you.

[eastof111]

Ok, good to know, will test a few other images when I get a chance.

[el bandido]

All of these different settings, are confusing to people, so I changed things and made them easier.

The attached file still writes to satellites.xml in etc/tuxbox, so take care of that by moving satellites.xml to etc/enigma2 Before loading.

Then,
Use circular lnb for 10750 in antenna setup. Do Not use User Defined!
The 10750 l.o. setting has been disabled. Using the circular lnb setting automatically sets the blindscan l.o. to 10750.

Since the 10750 Menu Setting is no longer needed, I may change it to 11250.... Either that or delete it.

[bronco]

Do not install any files from this thread unless you want to test.
We have a plugin section for Enigma2, and you should be able to find a blindscan plugin in that section to work like you have described.Make a backup before you install anything! These plugins do not support 11250 l.o. at this time. 9750,10600, and 10750 are the only ku lnb l.o. frequencies that are supported.

Just to make sure ..
Is this the file & instructions to follow. Using VU+Solo HD SE with Vix-Apollo 166 image
blindscan10750_1_mipsel.ipk

I took from here:
[Only registered and activated users can see links. ]

[el bandido]

That looks OK. Try it and see what happens.

[el bandido]

This one needs to be checked to see if the transponders are being scanned from 11700-11850. I have no way to know because I do not have a 10750 lnb connected in my antenna system. It needs to be checked so I can move to something else.

LNB Settings, Use universal for universal, and circular for 10750. Everything else is automatic. Satellites.xml is still being automatically written to in etc/tuxbox. I will do something with that once the bottom 150 MHz of the scan is checked and found to be working.

[bronco]

I have tried to install the File and not appears on searching Menu after reboot..
I have tried many times and reboot the receiver by back switch and through the menu and nothing. Using VU+ solo SE HD with Vix Apollo -166 image
[Only registered and activated users can see links. ][Only registered and activated users can see links. ][Only registered and activated users can see links. ][Only registered and activated users can see links. ]

[el bandido]

You did not install anything. Look at your last picture.

I cannot see what you did in the third picture, but you should highlight the plugin you wish to install, then press the OK button. Then Press the green button on th remote.
When the plugin is installed, you will see a number value of 1 or more instead of the zero that is shown in your picture number 4.

[bronco]

[Only registered and activated users can see links. ][Only registered and activated users can see links. ][Only registered and activated users can see links. ]
I have tried again..
Yes, on my first test I miss to "select" the file (on Green) by "Ok" button
On my second test seems that the file is installed but with "error message"