Looking Help to set My Switchs and LNB's enigma2

[el bandido]

Where are you located?

[Only registered and activated users can see links. ]
Look in post#12 in the above link and download the user manual for Vix. Enigma2 all operates almost the same and that manual gives a good description of how to set things up.

Information on how your antenna and fta system is set up would be nice, such as how the switches are connected together, and what lnb or other device is connected to each switch port. A diagram or drawing would help, but a good written description will work too.

[bronco]

Where are you located?

[Only registered and activated users can see links. ]
Look in post#12 in the above link and download the user manual for Vix. Enigma2 all operates almost the same and that manual gives a good description of how to set things up.

Information on how your antenna and fta system is set up would be nice, such as how the switches are connected together, and what lnb or other device is connected to each switch port. A diagram or drawing would help, but a good written description will work too.

Thanks Good Information..
Understanding what I am reading on This Manual
*The Manual said:
Disecq A,B,C,D(for 4/1 switch)
I guess:
port 1= A
port 2= B
port 3 =C
port 4 = D
Is Correct?

*In regards switch 4x4 (0 / 22 KHZ)
This is what the Manual said:
Futhermore You can set the Tuner to use Voltage and 22 KHZ(for polarization Horizontal/Vertical) switching and frequency band High/low): Normally set to "Yes" (default) and to send disecq Only on satellite change: Normally set to "No" (default)

I guess I need to Set "Yes" If my satellite is 4x4 side ON
I am Not sure If set "Yes" or "No" If My satellite is 4x4 side OFF
What you recommend??