My 10' Channel Master bud is presently arcing from 11-127w. I use my 8' Fortec solid for the circular sats from 11-53w so the fact that I cannot scan sats from 131-139 west is a waste for me. I plan to loosen the main clamp on my actuator and push it up about 1/2" and add an additional part of steel to where the the main actuator is attached to the dish. The latter will ensure that the motor and dish do not meet when I am nearing the end of my arc.

I will be doing this with my good neighbour Lexmark tomorrow morning. As long as my arc starts at approximately 31.5w, where the first linear c band sat is located, then I will be able to extend it past the present 127w to accomodate those 5 sats from 131-139.