Thread: Save Database

Results 1 to 3 of 3
  1. Collapse Details
    Save Database
    #1
    Join Date
    Nov 2012
    Location
    Eastern Washington
    Posts
    50
    Post Thanks / Like
    Contribute If you enjoy reading the
    content here, click the below
    image to support our site.
    Click Here To Contribute To Our Site
    My Openbox X5 has FW dated Feb 2014. After setting everything up, I'm trying to save my settings to a USB drive. When I access the page for doing this, the last option is Load/save. When I click on the option the only choice is to load a DB to the box. (No option to save)

    The X5 manual shows Load and Save on 2 separate lines. My screen only shows one.

    Am I missing something?

    Thanks
    Reply With Quote
     

  2. Collapse Details
    #2
    Join Date
    May 2011
    Posts
    5,807
    Post Thanks / Like
    You need to have the USB inserted in the box before accessing the Edit Channels section. When you go to the Load/Save DB area you need to hit OK over the /udska1 directory you will see immediatly the Save DB blue boton in the right lower corner.

    Note:
    USB should be formatted as FAT32
    X2 Premium III HD, Openbox X5/ S10, Gsky V3/V6, iSmart m100
    Reply With Quote
     

  3. Collapse Details
    #3
    Join Date
    Nov 2012
    Location
    Eastern Washington
    Posts
    50
    Post Thanks / Like
    Thank you very much Carlos! I was too busy looking at the "Load By USB" at the top of the screen and did not see the "Save" at the bottom.
    Reply With Quote
     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •