Yesterday I installed a GEOSATpro GS120 on my 1.0 M Ku dish, The Pole/Post is plumbed, have set the motor mount latitude scale to my location. How true are the readings of the numbers stamped on the Latitude bracket. If an inclinometer is placed on the face/edge of where the LNBF and receiver coax connections and where the rotating tube are located, will this inclinometer Latitude angle reading be equal to the Latitude scale reading. When the inclinometer was placed at the above mentioned place, there is about four and a half degrees difference from the bracket reading anf the face/edge of the motor.

Having difficulty on finding satellites with this setup. I am beginninh to doubt the scale rading for the dish elevation bracket readings as well.