Just an observation for IPTV fans out there. I have been using 12 Mbps connection speed for a few years and have always been satisfied with its performance. Mainly, because my wife uses Netflix in the bedroom's tv monitor via wifi and she's never complained about cut outs. We may have had a few hiccups now and then, but nothing serious to mention in those years.

The only compalints I've had, was with the Raptor and X7, both hard wired, hic cupping every once in a while, mostly on 720 and 1080 feeds from over the pond. Plus, it would usually take a few seconds for the video to appear and sometimes longer for the audio to synch with the video. My X2, hard wired, would take much more time displaying the wheel loading logo before any video popped up and audio synch. It also has much more and consistent cut outs. But note, the price spread between receivers is significant, so that is NOT a fair comparison; just an observation.

Today, I upgraded to 32 Mbps to experiment. Now, the Raptor's feeds pop in almost instantaneously and in synch with no hic cups, unless I visit a known bad Euro or Asian feed site. This tells me the buffer memory allocated is doing the job the coders intended; even prior when presented with a slower speed. The X7 on the other hand, is still a work in progress. But, it was a big improvement after the upgrade. I could still use some tweaking.

If I intended to watch streams mostly in the U.S., I would say 12 Mbps accomplished the needs for us. But, since I will be watching the Euro streams, I think I will stay with the higher speed for now.

Also to consider, is that your modem has the proper Docsis firmware support for the intended speed. Plus, the router being utilized can keep up with the modem's speed.

Again, just an OBSERVATION about connection speed.