"I am still having problems with this and the last FW. I change to another channel/sat and I get no video or audio but have good signal quality. I than have to turn off and on or go into antenna settings back out and than I have TV again."

This happens to me still, even with the new firmware. Example....

If I scan the arc for KU sats from 45 to 116 using my BUD, it will work fine until....

I reassign my switch settings for each KU sat previously scanned to the individual lnb and dish pointing to that particular sat. Then, some of the scanned sats will display video and others will not. Only cure is to rescan using the NEW switch settings. Sometimes rebooting will help cure this glitch, other times not.

I can only surmise that the firmware still has spurious switch settings, because I don't have this problem with my other receivers using the same setup.