It is in the software/firmware. Anaconda moves dish with ease to reference. If I select a sat after going to reference.....in the settings go to area then it will go there. Once there.... tuning another sat results in no movement. So dish goes to right place...will move to reference...will move east and west. in my mind it has to be software/firmware command issue...either not sending it or etc. I have 22K on for my KU maybe that is a problem. my cable goes straight from anaconda to motor then to switch. Seems to be problem with 22k on and usals. I turned 22 off and tuned knowing there would be no signal...then turned 22 back on and dish had moved. So it is in the 22/usals combo. Def. 22 problem...just turned it off then back on after 10 seconds and dish moved after not moving. I had it on G3c KU and then tuned 101. Dish did not move. Went to settings turned off 22 then immediately turned it back on...nothing. Then turned it off and left it for 15 seconds ..turned it back on and signal was there...hope this helps.
By the way like the firmware...any streaming in it? Thanks guys.