December 25, 2012 Firmware

[norman881]

I have installed this firmware after completing a factory reset after each install3 (three) times. I cannot save the USALS settings. I am still evaluating other issues from previous versions.

Sincerely
Norman

[rrob311]

Yes I just loaded it and it is doing the same here. Sets to 0 every time. I am going back to the previous firmware for now.

[ViP3R]

Yes I just loaded it and it is doing the same here. Sets to 0 every time. I am going back to the previous firmware for now.

I asked for a fix for this after reading.

[rrob311]

I ran into a similar issue before and now I am trying to figure out which firmware actually works for the USALS. I remember having to back out of the setting and then it saved.

[rrob311]

I think the workaround I used was after you enter the USALS settings enter GO, and then after that choose drive to zero and then back out of it when it finishes moving and see if that works. It may save that way. The older firmware had a save option that you would press and the newer firmwares do not have a save button.

[ViP3R]

I'm told the engineers are looking at this and will solve it soon.

[cpr43]

Vyp3r

could it be possible to invite Mr Wang from X2 to register here???? Maybe he can get the inputs faster and straight to him. he can also keep us up to date. They keep sending different e-mails to different member thus creating confussion.

Carlos

[rrob311]

Forgive me for being off topic some but has anyone else noticed there are lots of wangs on the alibaba sites. LOL

[cpr43]

probably same as Rodriguez in south america and Smiths in North America

[Gary Bidwell]

His name is Ma Wang.