I was a little worried about my sat position settings when I got my Anaconda. I had an openbox S10 and had programmed all of my sat positions into my Gbox Positioner. I did not want to change all of the positions and have to do all of that . it would be nice to just be able to change the anaconda to that diseqc position for that Sat. We know that can't be done in the actual firmware of the anaconda.... they are preset. However with the octagon channel editor that is here in this forum you can change them and load them back into Anaconda...and all is well. Didn't have to change anything in my setup....just edit sat settings in Channel editor. Now I can swap any box for another and all the settings are the same.
I just know that one of the draw backs to the Anaconda had been the inability to edit sats diseqc positions. But it can be done.

great great box!!!! If they can speed up the blind scan and incorporate Channel streaming (like it can in e2) THEN this box will be almost perfect.