Results 1 to 3 of 3
  1. Collapse Details
    New E2 from PKTeam
    #1
    Join Date
    May 2012
    Posts
    258
    Post Thanks / Like
    Contribute If you enjoy reading the
    content here, click the below
    image to support our site.
    Click Here To Contribute To Our Site
    Go here:

    [Only registered and activated users can see links. ]

    Works great on my system. Streamed beautiful CBS 4:2:2 to computer and played live great.

    Only two problems:

    1. No 60hz only 50. Leaves picture quality not as good.

    2. Some AC3 will not scan in and play. Most do. i could not get LORACS on 101 C band to play Audio...or ION EAST HD and ION PACIFIC HD on 103 AMC 1 Cband.

    Nice work by PKteam.
    Reply With Quote
     

  2. Collapse Details
    #2
    Join Date
    May 2012
    Posts
    258
    Post Thanks / Like
    there is a fix for ac3 no audio. If you use the dreamset e2 channel manager...go to where you edit the pids for the channel that won't play ac3 audio. Make sure yu put a 0 for audio and put audio pid in ac3 box. THEN you must click the box that says USE PIDS and make it say yes. Then load channel list back into receiver and they will play. Also since the change in the Puerto Rico mux on G 16C it will scan in the new HD fox and HD nBC as data. have to change that to 1 for TV. Also have to use AC3 audio fix listed above. They will then come in and play fine. hope this helps. The ac3 audio was a big draw back to this image. It must delete the PIDS for audio for some reason. Will be a pain to fix for all channels but better than no audio.
    Reply With Quote
     

  3. Collapse Details
    #3
    Join Date
    May 2012
    Posts
    258
    Post Thanks / Like
    PS I have also found that E2 will change stuff even after you have changed it in the channel editor...ie ch name etc. make sure you check the box LOCK. this will not allow E2 to change anything.

    PS2
    When using the editor, just below PIDS for a channel, you will see video type, ac3 delay etc. Make sure that Video type says 1. On the ac3 channels sometimes it changes to 0 and then will show no video only sound once you have fixed the ac3 audio. Make sure both video types (top and bottom) say 1.
    Last edited by mountaineer; 10-14-2012 at 10:09 AM.
    Reply With Quote
     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •