I found this on another website - I loaded the NTSC firmware and I had instant access again. And then I upgraded the firmware to the newest version.
Bob
How to Escape From PAL Video Format
1. Format USB flash drive to fat32 and install the unzipped NTSC firmware file for your model of receiver onto the flash drive.
2. Insert USB drive into the receiver. Wait 15 seconds then press the red remote button, press the left arrow button, then press the OK button.
These steps will cause the firmware to load
Thread: Raptor Factory reset
Results 1 to 10 of 17
Hybrid View
-
08-01-2012,07:34 PM
Last edited by brr5; 08-01-2012 at 07:39 PM.