Quote:
[Preperation before install E2]
1. Update your boot loader --- 'UpdateLoaderLx.x6' version(Latest version) by Booting upgrade mode.
(Turn on your receiver while pressing CHANNEL UP button on the front panel, until SCAN message shows up
=> 'COMPLETE' message shows up, then Turn off and on)
2.USB Memory
* Bootable USB memory required.
* File system must be FAT32. (Recommend FAT32 format in advance)
* High performacne USB memory recommended.
(If USB memory stick is old or performace is low, USB booting can be failed.)
[E2 Installation]
1. Save uImage (common to all models) and root.img (specific to each model) to your USB memory.
2. Connect the USB memory stick to receiver. (Rear or Front side)
3. Turn on the receiver with pressing CHANNEL DOWN button on the front panel, until SCAN message shows up.
4. The front display will show 'ON' first, then keep showing some messages more.
* 'ON' means that reading E2 image from the USB memory is started.
5. 'ENIGMA2' logo displays for a while.
6. After displaying E2 logo, if your screen is black, select output mode by pressing channel Up & Down botton on your RCU.
Once select your output mode, press OK button to adapt it.
(Currnet output mode will display on your front LCD or VFD)
C = Component
H = HDMI
HC = HDMI-PC
S = Scart
6. Now Enjoy E2 !
** After installation is finished well, E2 is available whenever your USB memory is connected to receiver before turn-on.
!!!!! [Important Notice] !!!!!
* Do not dis-connect USB memory from the receiver while E2 is working.
<Roll back to original S/W>
1. Turn-off receiver
2. Dis-connect USB memmory from the receiver, then turn-on the receiver.