Printable View
I have never been able to set this up. The problem is when I switch the position from USALS to Diseqc the dish automatically moves to wherever it wants. There are 63 positions and I am unable to switch it and bump the dish in the menu. Any techniques that anyone uses would be much appreciated. This is pretty much the only receiver that is difficult to setup this function for me.
On 1.2 diseqc o ption You need to store each sat position one by one before to
well my mount is off a bit so the only way I can think to store positions is to disconnect the coax when the sat is set to position and then switch it from USALS to DISEQC and hit store. Then try to bump the motor from there. Doesn't seem very efficient.
Maybe that 's will work .but make sure each sat to be on different number .Example 61w -position number&save 1 ,
72w -position number&save 2 .... etc . 83w -number 3 ....
Ya, the main problem I have is when I switch to diseqc it automatically moves the dish. Most receivers it will not automatically move and it will allow you to store a position. I only have like 12 positions I need to setup.
I have that box and its pain in the a..s ,when have to store entire my arc . from 15w till 113w KU bands
Usually I manyalli find each bird moving the dish with west-east buton ,then store the position
What type of motor are you using? it sounds like the Diseqc 1.2 positions have already been stored in the motor so you need to erase them first. Then the motor will not move when you select diseqc 1.2.Quote:
Originally Posted by rrob311 [Only registered and activated users can see links. Click Here To Register...]
Its an SG2100 I think. I remember now you noted that the positions are stored inside the motor right? How do I go about erasing them? Would I be able to use the same position numbers in each receiver and then not have to change them?
the positions are stored in the receiver , not in the motor, If you want to reset the moto r ,just move it with the manual buton east-west to ZERO on the mark and then reset with a thin pin in the hole. .THAT s help if you want a use USALS optoin ,when the zeroed motor is the import ,but not in the 1.2 disekqc .
2 days ago Iput my FLU for accurate blInd scanning 22w Ku , AND IT MESS MY ENTIRE STORED POSITION on the openbox . I had nightmare all day to restore all my positions..
Diseqc 1.2 positions are stored in the motor so they may be transferred to different receivers.
Information on how to clear the stored positions should be in the owner's manual for the motor. Some receivers will allow you to clear all stored positions too. Look in the S9 diseqc 1.2 menu or the receiver's owner's manual.