Enigma 2 and diseqc 2.0 switches.

I use only 1 lo of 13850 and adjust the tps from the opposite polarity to that lo...only have one polarity available to each stacked lnb so they cant change.

Anyway I found a solution/workaround !!!!!

I change the ones that werent working to Cband LO. That apparently released the control of the 22. So even though they are KU lnb I set the LNB in E2 to be a cband LO. Then adjusted the tps frequencies to that of 5150 instead of 10750 and wala it worked. The bandstacked lnbs on only one polarity must mess with the 2.0 and cause it to tryand fit all the ranges from both polarities and 22 on/off onto the 4 ports....therfore messing everything up..when changed to cband lo then it removes that "thought" since one is ku and one is "cband"
Ha tricked it...knew there was a way!

Thanks for all of your help!!!!!!!!

LOL

I guess you could use the Ka lnb setting the same way.

Glad you found a way to make it work!

BTW,
That is a very nice switch! Found a Video of it.

[Only registered and activated users can see links. Click Here To Register...]

Would you believe I got it for $40 shipped on ebay? I was shocked...it is an excellent switch...almost no insertion loss.

Thanks for all of your help!

I think the NimManager file could be changed so the LOF changes automatically in the receiver when the polarity switches.
Here is an incomplete example:

Quote:

---

if currSat.voltage.value == "polarization":
if config.Nims[slotid].diseqc13V.value:
sec.setVoltageMode(switchParam.HV_13)
else:
sec.setVoltageMode(switchParam.HV)
elif currSat.voltage.value == "13V":
sec.setVoltageMode(switchParam._14V)
sec.setLNBLOFL(10750000)
sec.setLNBLOFH(10750000)
elif currSat.voltage.value == "18V":
sec.setVoltageMode(switchParam._18V)

---

I guess something for me to look at in the future.